¡El Quantrol series is available in the three DIN formats 48 mm x 48 mm, 48 mm x 96 mm, and 96 mm x 96 mm. It is used for two-state and three-state control applications as well as for the control of regulating valves or SCR power controllers via a continuous controller output. ¡El universal analog input for RTD temperature probes, thermocouples, or current/voltage sig nals is user programmable. ¡El setpoint value, the actual value, and all parameters are dis played on two seven-segment LED displays (red/green) with one or two decimal place(s). The values can be displayed in °C or °F. Depending on the format, up to five relay outputs with a switching capacity of 3 A / 230 V or up to four logic outputs 0/14 V are available. ¡El switch po sition of the relays or logic outputs is displayed using yellow LEDs. Different functions can be as signed to these outputs. An analog output 0 to 10 V or 0(4) to 20 mA is configurable as continuous controller output, actual value output, or setpoint value output. Using the binary input, the device settings and operation can be locked, a ramp or the timer can be activated, or self optimization can be initiated. ¡El supply voltage is optionally AC 110 to 240 V or AC/DC 20 to 30 V. ¡El controller has a ramp function with adjustable gradient for constant setpoint change. In ad dition, a special firing curve for small pottery kilns can be used which allows controlled starting and time dependent firing. ¡El user can enter setpoint values, gradient, and firing time directly at the device. ¡El device can be connected to host systems or devices using the RS485 serial interface. In stead of operating the device from the front, the user can also program the controller using the setup program and USB interface; this requires no additional voltage supply for the controller. ¡El Quantrol series, like all JUMO controllers, is also equipped with reliable JUMO self-optimi zation (autotuning)