¡El Siemens Circuit Breaker es de alta calidad!
circuit breaker VL160X N standard breaking capacity Icu=55kA, 415V
AC 3-pole, line protection Electronic Trip Unit TM, LI In=32A, rated
current Ir=25...32A, overload prot. II=300A, short-circuit prot. without
auxiliary release without auxiliary/alarm switch
Model
type of the driving mechanism / motor drive No
design of the overcurrent release TM
General technical data
number of poles 3
size of the circuit-breaker 3VL1
mechanical service life (switching cycles) / typical 20 000
electrical endurance (switching cycles) / typical 10 000
utilization category A
performance class for circuit breaker N
reference code / acc. to DIN 40719 extended
according to IEC 204-2 / acc. to IEC 750
Q
operating frequency / maximum 120 1/s
Voltage
Rated operational voltage Ue / max. 690 V
insulation voltage
rated value 800 V
at AC / rated value 800 V
surge voltage resistance / rated value 8 kV
operating voltage
rated value / maximum 690 V
for main current circuit / at AC / at 50 Hz /
maximum
690 V
for main current circuit / at AC / at 60 Hz /
maximum
690 V
for main current circuit / at DC / maximum 500 V
Protection class
protection class IP IP20
protection function of the overcurrent release LI
Current
continuous current / rated value 32 A
derating temperature / for the rated value of the
continuous current
50 degrees centigrade
adjustable current response value current
of the current-dependent overload release / fullscale value
32 A
of instantaneous short-circuit trip unit / initial
value
300 A
of instantaneous short-circuit trip unit / full-scale
value
300 A
Main circuit
operating frequency
1 / rated value 50 Hz
2 / rated value 60 Hz
operational current
at 40 degrees centigrade / rated value 32 A
at 50 degrees centigrade / rated value 32 A
at 55 degrees centigrade / rated value 29.8 A
at 60 degrees centigrade / rated value 29.8 A
at 65 degrees centigrade / rated value 27.5 A
at 70 degrees centigrade / rated value 27.5 A
Mechanical Design
height 157.5 mm
width 104.5 mm
depth 106.5 mm
fastening method fixed mounting